BAT BATmode 2S User Manual page 56

47 USER MANUAL BATMODE 2S/2S+ SYSTEM
Send LAN-IP!
Enable Status-Mail!
Disable Status-Mail!
Enable Status-SMS!
Disable Status-SMS!
Send condition!
Set calibration 1/0/-
20.1/91.2/37.0!
Send calibration!
Add Security Number:
+491601234567!
Set SIM-Card Credit USSD-Code
to *100#!
Send SIM-Card Credit!
Execute USSD-Code *100#!
The LAN IP address of the BATmode is send to the
sender of the SMS.
Enables the transmission of a daily status mail.
Please consider that correct mail settings have to be
inserted to use this command.
Disables the transmission of a daily status mail.
Enables the transmission of a daily status SMS. Please
consider that correct SMS settings have to be
specified to use this command.
Disables the transmission of a daily status SMS.
Current temperature and precipitation values are
sent to the SMS sender.
Change the calibration values of a microphone
channel. Required parameters are:
1. Channel specification (1,2,3 or 4)
2. Microphone without or with test signal speaker (0
or 1)
3. New "Full Scale Level of Reference Signal" in dBFS
4. New "SPL Level of Reference Signal" in dBSPL (leave
blank for microphones without test signal speaker)
5. New "Level of Trigger Threshold" in dBSPL
Monitoring must be stopped to execute the
command.
Current calibration values of the microphone are sent
to the SMS sender.
Adds the phone number +491601234567 to the
Security Numbers. Only these numbers are allowed to
send SMS commands to the BATmode system.
Sets the USSD code for querying the prepaid credit to
*100#
Sends the current amount of the prepaid credit. For
the query the "Credit USSD-Code" must be set
correctly.
Executes the USSD code *100# and sends the
response to the SMS sender. This can be used, for
example, to query or top up the prepaid credit.