Advertisement
Advertisement
Table of Contents
Related Manuals for BAT glo
Summary of Contents for BAT glo
-
Page 3: Safety Instructions
SAFETY INSTRUCTIONS Read all instructions before using this product and keep Do not leave the glo™ tobacco heater or any of its accessories the User Guide in a safe place for reference. exposed to a heat source or in a high temperature location such as direct sunlight on a car dashboard. -
Page 4: What's In The Box
10°C to 45°C. At temperatures between 0°C and 10°C the glo™ USB AC adaptor will recharge the glo™ tobacco heater at half the normal rate. Do not use the glo™ USB AC adaptor Cleaning Brush at temperatures below 0°C, or above 45°C. -
Page 5: Product Diagram
PRODUCT DIAGRAM 01 Heater entrance 02 Slider door 03 Control button 04 USB charging port 05 Cleaning door... -
Page 6: Charging Status
Charge Insert a neo™ stick Insert the USB cable into the Slide open the shutter on top of the glo™ tobacco heater USB charging port of the glo™ and gently insert a neo™ stick until you feel the stick tobacco heater and connect touching the bottom of the glo™... - Page 7 Hold down the control button on the glo™ tobacco heater The lights on the control button will begin to rotate to for 3 seconds to start the heating process. The glo™ tobacco indicate that BOOST has been selected. After 10 seconds, heater will vibrate gently after these 3 seconds to indicate all 4 lights on the glo™...
-
Page 8: Battery Status
You may stop your session at any point by holding down the control button for 3 seconds on the glo™ tobacco heater. The glo™ tobacco heater will gently vibrate to let you know it’s turning off. A session cannot be paused. The existing neo™ stick must be removed and replaced before the next session can begin. - Page 9 Simply rinse brush under running water. Please make sure Ensure the glo™ tobacco heater has been allowed to cool that the cleaning brush is dried before using again with glo™ for a minimum of 5 minutes before cleaning. tobacco heater.
-
Page 10: 10 Troubleshoot
ERROR CODE SYMPTOM POSSIBLE CAUSE SUGGESTED ACTION The glo™ tobacco Move to a cooler area heater may be above and/or wait for the glo™ the battery’s maximum tobacco heater to temperature. cool down. The glo™ tobacco Move to a warmer area heater may be below and/or wait for the glo™... - Page 11 Care Center for support. If you have read the troubleshooting information and are still having problems with your glo™ tobacco heater, please contact the glo™ Care Center for additional help glo™ Care Center and advice.