Table of Contents
Advertisement
45
USER MANUAL BATMODE 2S/2S+ SYSTEM
By default, the e-mail is sent via an SMTP server of bat bioacoustictechnology (<Use default SMTP
server>). The status mail can be sent with this SMTP server via port 25 as well as port 587. Please select
the appropriate port in the drop-down menu <Port>. If you want to send the status mails via an
alternative SMTP server, please select <Use alternative SMTP server> and set the <SMTP server
settings> accordingly.
You can send a test mail to the specified address(es) by pressing <Send Test Mail>. If a connection to
the speficied SMTP server is not possible or an error occurs, this will be displayed in the message bar.
A slash character ("/") separates values of different microphone channels or measurement points
within the status message.
To send a status mail, an active Internet connection is required in which the port
selected under <Advanced Settings
4.2.2.3
<Remote SMS> Box
Basic remote commands can be transmitted to the BATmode system via SMS. If you want to allow
SMS remote, check the box <SMS Remote>. To prevent SMS commands execution received from
unauthorized persons, telephone numbers from which SMS commands should be accepted must be
stored in the <Security Number(s)> field. The numbers are to be entered in international format
separated by semicolons. Available commands and the corresponding system responses are listed
inTable 14
If the check box <SMS Remote Feedback> is enabled, the system confirms executed
.
command SMS via response SMS to the sender of the command.
To use SMS remote commands an unlocked SIM card has to be inserted in the
BATmode. Basically, bat bioacoustictechnology recommends the use of PIN free SIM
cards, because only an inactivated PIN allows to unlock the SIM card after a reboot of
the system automatically. Furthermore, the system has to be installed in an area with
sufficient mobile network coverage.
must not be blocked.
>
Advertisement
Table of Contents
