Troubleshooting - Hyundai SI 268 Instruction Manual

GB
The iron is equipped with a permanent decalcification system ANTI CALC that does
not require maintenance. But the system cannot fully prevent creation of calcareous
sediments.
V. TROUBLESHOOTING
Problem Cause
Iron is not heated. Power supply not connected
Thermostat regulation wheel is in
MIN position
Iron does not crea- There is no water in the container Pour water into the container
te steam
Steaming regulator is in
position
Low temperature is set for activa-
ting the DRIP-STOP function
Iron does not crea- Low temperature is set for activa-
te steam shock ting DRIP-STOP function
The function of steam shock was
used too often during a short
period of time
Sprinkling equip- There is no water in the container Pour water into the container
ment (additional
The water system is aerated
spray) does not
sprinkle water
Solution
Check the cord, plug and the socket
Set the wheel to position • / •• / ••• or
MAX
Move the regulator into the steaming
position
Use the regulation wheel to set a
temperature, during which you can use
steaming and wait till the iron is heated
for using it
Use the regulation wheel to set a
temperature, during which you can use
steaming and wait till the iron is heated
for using it
Let the iron heat and wait for a while
before using the electric shock function
again
Tighten finger on the additional spray
jet hole and at the same time press the
sprinkling device button several times
24