Hyundai SI 268 Instruction Manual page 22

GB
(clicking). This is normal situation and does not form the reason for warranty claim related
to the appliance.
Recommendation
Control H (Fig. 2) is marked with international symbols that recommend the optimum
ironing temperature and they are the same as marking on some types of laundry
and textiles (Fig. 3). When the temperature is increased from the cold state or if the
temperature is set from higher to lower, we recommend waiting for a while (see the
information on the display and listen for sound signalling) due to stabilization of the ironing
plate temperature.
Steam ironing
Hold the iron in your hand, turn the steaming regulator D to the position
and slide the cover C to open the filling container lid. Pour in water to the container I
(Fig. 4) with the enclosed cup O and close the filling hole lid in the opposite direction. Keep
the position of the iron for pouring in water. Put the iron to the rest position (Fig. 7) and set
the regulation wheel H to the marked area for steaming (Fig. 2
M to a socket. When the control light G goes off, move the steaming regulator D away from
handle. The more you move the regulator towards MAX, the bigger amount of outgoing
steam there will be (Fig. 5). Place the iron to the rest position, automatic creation of steam
will stop (more steam may be going out for a short time).
Warning
- For all normal ironing the middle adjustment of the steam amount is recommended. Only
on ironing the linen fabric, thick cotton and similar fabrics the adjustment of the steam
amount to maximum value is recommended. Setting to high-pressure steam ironing os
recommended only if the regulation wheel H is set to temperature setting •••.
- Be extra careful to avoid accidental pushing of the SELF CLEAN button.
- When water container I is filled with water over the permitted limit (MAX. 300 ml), steam
can be created even in the rest position.
- At places with hard water we recommend diluting it with distilled water. You will get
the information about water hardness at the water-management authorities, or at the
local sanitary station. For water hardness > 15 °N we recommend filling the iron in the
following ratio:
Water hardness
medium
hard
very hard
Sprinkling appliance (additional spray)
It is used for moistening fabrics and it is effective in ironing extremely creased fabrics. It is
activated by repeated pressing of additional spray button E. We do not recommend
applying additional spray for fine fabrics (e.g. silk and synthetic) as the used water may
stain the fabric.
Intensive steaming (steam shock)
Use only if the steam ironing is insufficient. In this case press intensive steaming button
F several times (Fig. 6A -
created by standard steaming.
Ratio of tap water : distilled water
). Thus you will get additional steam except for the steam
22
). Plug the power cord
2 : 1
1 : 1
1 : 2
(Fig. 5)