Troubleshooting; Technical Specifications - Hyundai SI 252 Instruction Manual

Troubleshooting

Problem
The iron is plugged in but the
soleplate is cold.
lThe iron does not produce
any stream.
Water droplets drip onto the
fabric.
Flakes and impurities come
out of the soleplate during
ironing.
Red light blinks and warning
sound beep.

Technical specifications

- Steam iron
- Ceramic soleplate
- Variable steam 0-35 g/min
- Horizontal steam 85 g/min
- Electronic safety auto-off indicator wich turn the iron off.
- Self cleaning
- Anti-Calc function
- Anti-drip system to prevent water escaping from the soleplate
- Dry/steam/spray, variable steam, vertical steam
- Large 260 ml water tank.
- Long power cord 3 m
- Water fillbeaker
- Color: blue
- Power supply 230 V ~ 50 Hz
- Power drain 2200 W
- Size: 30 x 14 x 12 cm
- Weight: 1,35 kg
We reserve the right to change technical specifications.
Possible cause
There is connecton problem.
There is not enough water in
the water tank.
The stream kontrol has been
set to positron „0"
The iron is not hot enough.
The cap of the filling opening
has not been closed properly.
You have been using hard
water, which has caused
scale flakes to develop inside
soleplate.
The safety shut-off function
has switched the iron off.
ENG - 32
Solution
Check the main cord, the plug
and the wall socket.
Fill the water tank.
Set the stream control to hi-
gher position.
Selectan ironing temperatu-
re that is suitable for stream
ironing. Put the iron on its heel
and wait until the amber pilot
has gone out before you start
ironing.
Close the cap properly. You
will hear a click
Use the self- clean function a
few times.
Move the iron to deactivate
the safety shut-off function.