Cleaning And Maintenance; Care And Cleaning; Troubleshooting - Hyundai SI 258 Instruction Manual

CLEANING AND MAINTENANCE

AFTER USE
• Set the steam selector knob to
• Disconnect from the mains supply.
• Open the water fillinginletcover.
• Invert iron and shake the iron to empty the water tank (fig.4), and then stand the iron in
a upright position to allow to cool.
• Always store the iron (with water empted from water tank) on its heel rest, not on the
soleplate. Even the smallest amount of moisture will cause corrosion and staining of the
soleplate if the iron is stored with the soleplate facing downwards.
• Any deposits, starch residue or size left on the plate can be removed using a damp cloth or
an unabrasive liquid detergent.
• The plastic parts can be cleaned with a damp cloth then wiped over with a dry cloth.
• Press the button and turn the handle to the low position (Fig. 5).

CARE AND CLEANING

• Disconnect from the mains supply by removing the plug.
• Certain fabric finish residues may build up on the soleplate, these may be removed by
cleaning with a rough cloth soaked in a vinegar water solution. Dry with a cloth.
• Do not use abrasives or scouring pads to clean the soleplate. Keep the soleplate smooth:
avoid hard contact with metal objects. Do not scratch or damage the surface of the soleplate.
• Wipe the outside housing with a damp cloth and polish with a dry one. Do not use abrasives
or harsh cleaners as they may damage the surface of the iron.
• Avoid scratching the plate with steel wool or metallic objects.
• To clean steam holes - simply use a damp cloth to wipe away any build up of lint or starch
from inside steam holes.

Troubleshooting

Problem
The iron is plugged in but the
soleplate is cold.
lThe iron does not produce
any stream.
Water droplets drip onto the
fabric.
Flakes and impurities come
out of the soleplate during
ironing.
.
Possible cause
There is connecton problem.
There is not enough water in
the water tank.
The stream kontrol has been
set to positron
The iron is not hot enough.
The cap of the filling opening
has not been closed properly.
You have been using hard
water, which has caused
scale flakes to develop inside
soleplate.
ENG - 27
Solution
Check the main cord, the plug
and the wall socket.
Fill the water tank.
Set the stream control to
higher position.
Selectan ironing temperature
that is suitable for stream
ironing. Put the iron on its heel
and wait until the amber pilot
has gone out before you start
ironing.
Close the cap properly. You
will hear a click
Use the self- clean function
a few times.
ENG