Access Flow2A Manual page 42

The drive unit
Miscellaneous options
rES Restore settings and track data, by pressing and holding the E button for 2s, a file can be selected to
restore (L00 till L99), selecting can be done by pressing the D or I button. When no files present or no SD
card is inserted the display shows 'L—'. When after selection the E button is pressed and hold for 2s the
restore will be executed. If successfully executed the system will reboot. If restore was not successful, an
error plus error sound will be thrown and the system returns to the main menu.
BU Back up the current rail data. By pressing and holding the E button for 2s, the rail data and history will be
stored on the SD card.
Clr Clear parameter and rail data, after pressing and holding the E button for 2s this must be confirmed by
selecting first the 'y' or the 'n' (the selected is indicated with a dot) and then hold E button for 2s. After
the clear has been executed the system returns to the main menu.
Crd clear rail data, after pressing and holding the E button for 2s this must be confirmed by selecting first the
'y' or the 'n' (the selected is indicated with a dot) and then hold E button for 2s. After the clear has been
executed the system returns to the main menu.
CPd clear mode -9- settings, after pressing and holding the E button for 2s this must be confirmed by selecting
first the 'y' or the 'n' (the selected is indicated with a dot) and then hold E button for 2s. After the clear
has been executed the system returns to the main menu.
CEr clear errors, after pressing and holding the E button for 2s this must be confirmed by selecting first the 'y'
or the 'n' (the selected is indicated with a dot) and then hold E button for 2s. After the clear has been
executed the system returns to the main menu.
FSd format SD card, after pressing and holding the E button for 2s this must be confirmed by selecting first
the 'y' or the 'n' (the selected is indicated with a dot) and then hold E button for 2s. After the clear has
been executed the system returns to the main menu.
brA brake test, after pressing and holding the E button for 2s this will be executed. If the test was successful,
the system returns to the menu, If not successful, an error with sound will be thrown
Upg
upgrade the firmware. by pressing and holding the E button for 2s, a file can be selected to restore (x.xx),
selecting can be done by pressing the D or I button. When no files present of no SD card are inserted the
display shows r--. When after selection the E button is pressed and hold for 2s the upgrade will be
executed. If successfully executed the system will reboot. If restore was not successful, the system
returns to the main menu and will give an error that there is no rail data or corrupt rail data.
AnR set account number, this can be used when the control board has been replaced or no account number is
present on the control boards memory; by pressing and holding the E button for 2 seconds, the left
segment of the display shows the digit number of the account number (0 is the most right digit) the
middle segment shows '-'and the right segment shows the value of the digit. Up to 9 digits can be
modified. Modifying the digit is done with the I and D button, selecting the next digit of the account
number is done by pressing briefly the E button. confirming the entry is done by pressing and holding the
E button for 2 s. Pressing the D and I button simultaneously will exit the account number menu.
42