Table of Contents
Advertisement
The drive unit
The middle digit is the number of the call and park unit.
The left digit is the halt position for this unit and can be adjusted by using the D button (call action).
The right digit is the park position and can be adjusted by using the I button (park action).
In this mode only existing stop positions are shown. Park positions are shown with a dot. Confirming the setting is
done by pressing the E button for 2 s.
Exiting this mode can be done by pressing and holding the E button (this can cause a false configuration of call and
park actions) or pressing the D and I button simultaneously.
Mode -9-
Miscellaneous options mode, in this mode other functionality is grouped. Stepping through the different options is
done by pressing the E button. The following options are available:
Miscellaneous options
Err:
Will show the errors that have occurred by pressing and holding the E button for 2s.
Pressing the E button will show the previous error. Holding the I button will show the minutes and holding
the D button will show the hours of that error. This timestamp is based on the hour counter and not an
absolute time.
HRS:
Will show the hours and minutes from the on-time hour counter. Holding the I button show the minutes
and holding the D button will show the hours.
rx
Configure the rail type, when a right rail is installed, the I button has to be pressed (rr) and when a left rail
is installed, the D button has to be pressed (rL). Confirming the entry is done by pressing and holding the
E button for 2s.
sx
Configure the swivel type, when manual swivel is installed, the D button has to be pressed (Sn) and when
an auto swivel is installed the I button has to be pressed (SA). Confirming the entry is done by pressing
and holding the E button for 2s
RPx
Configure the repeater type, default no repeater is installed. To install a repeater, the I button has to be
pressed (RP1). To un install a repeater, the D button has to be Pressed (RP0). Confirming the entry is
done by pressing and holding the E button for 2s.
CHx
Configure the RF channel, CH0 till CH4, selecting the channel can be done by the D or I button.
Confirming the entry is done by pressing and holding the E button for 2s.
V1x
Configure the audio volume for normal sounds, V10 till V19, modifying can be done by the D or I button.
Confirming the entry is done by pressing and holding the E button for 2s.
V2x
Configure the audio volume for error sounds, V20 till V29, modifying can be done by the D or I button.
Confirming the entry is done by pressing and holding the E button for 2s.
V3x
Configure the audio volume for alarm sounds, V30 till V39, modifying can be done by the D or I button.
Confirming the entry is done by pressing and holding the E button for 2s.
Lx
Configure the LED intensity, L0 till L7, modifying can be done by the D or I button.
Confirming the entry is done by pressing and holding the E button for 2s.
bAt
Configure the battery safe voltage, 14.0 till 32.0, modifying can be done by the D or I button. Confirming
the entry is done by pressing and holding the E button for 2s.
bAS
Base sensor angle, shows the current angle of the base sensor,##,#
CHr
Chair sensor angle, shows the current angle of the chair sensor, ##,#
SAF
Safety sensor angle, shows the current angle of the safety sensor, ##,#
Spx
Configure the safe position, Sp0 till Sp9, modifying can be done by the D or I button. Only programmed
HALT positions can be configured. Confirming the entry is done by pressing and holding the E button for
2s.
41
Advertisement
Table of Contents
