Advertisement
PHASE 2 – INSTALLATION
2.1 INSTALLATION
2.1.1 • Place the cab box raiser between the front seats.
• Adjust the position forward or backward to avoid any seat armrest or mechanical handbrake levers.
⚠
WARNING: Verify with the vehicle manufacturer before drilling through the floor, that no wires, cables
or other items are underneath. Adjust the position of the cab box raiser to avoid any items underneath.
• Mark the location of the 4 holes.
• Drill and insert the 4 Plusnuts. See Section 2.3 on using the Plusnut tool.
2.2 INSTALL WITH 5040 OR 5045 CAB BOX
2.1.2 • Assemble the cab box to the riser. Refer to the 5040 or 5045 Cab Box for installation instruction.
• Lower the cab box and raiser to the floor. Secure with fasteners.
NOTE: 5040 and 5045 Cab Box are separate units.
For technical support, contact us at 1-800-565-5321
TOOLS
q Cordless drill
q 1/2" Drill Bit
q Plusnut tool
q 7/16" Socket
HARDWARE USED
4×
TOOLS
q Cordless drill
q 7/16" Socket
HARDWARE USED
4×
5045 SHOWN
5047 Installation Guide | REV. A1 | Page 4
#94-130 1/4" Plusnut
#90-110 Hex Bolt 1/4" × 1-1/4"
#98-106 Flat Washer
Advertisement
