Table of Contents
Advertisement
4. TROUBLE SHOOTING
There may be various reasons for the abnormal of the unit. Therefore, if the unit does not work properly,
check the unit according to the procedures shown in the table below.
Problem
LED on front panel
Does not light
No Picture or Sound
Black-and-white
Screen or V-Hold
The remote controller
is not working
Distorted menu
screen
Not working
Possible causes
AC Power cord disconnected
Wrong connection of the
Video/audio output to TV input
Terminal
Wrong connection of antenna
cable
Wrong direction of antenna
No signal or weak signal
Wrong setting of channels
Information in MENU screen
Your TV mode is different from
broadcasting mode
Battery exhausted
Fluorescent light interfering with
the remote controller
Remote controller is incorrectly
aimed
Too high brightness and contrast
level of TV set
Process Down
Remedy
Connect power cord properly into the
power socket
Connect two terminals correctly
With scart cable or RCA or RF
cable
Connect the antenna cable
Correctly
Adjust the direction of antenna
Check the cable connections,
Type the setting value correctly
Use TV of same mode
Connection to the receiver and TV
Change the batteries
Switch off the light
Aim the remote control at the
receiver
Adjust brightness and contrast to low
level
Remove the power code or
AC reset switch OFF/ON
ⓒ 2007 by Panarex Electronics 39
Advertisement
Table of Contents
