Table of Contents
Advertisement
5.2 Factory Setting
Once the Factory setting is selected and the collect password is given by pressing 4-digit numeric keys followed by OK
key, whole parameters are changed to the value written in the factory. That is, factory setting functions your STB (Set
Top Box) the first stage. If you do not want to continue this mode, press EXIT key before you enter password.
Common password is "0000". In case selected password is forgotten, call Pansat's dealer to get factory master
password.
You can select factory setting as follows:
-Channel Data default setting
-All Data default setting
5.3 Data Transfer (Receiver to Receiver)
1) Connect null modem RS232 Cable (Pin #2 & #3 twisted) between master and slave receiver.
2) Hook up the master receiver to the TV and select transfer mode.
3) Turn the slave receiver power off/on to start.
Warning!
Do not disturb data transfer by touching any Remote button, RS232 Cable, IF Cable, RCA Cable etc.
during data transfer period. Interruption of data transfer could damage the receiver's Flash memory chip which makes
the receiver dead and void warranty.
6. USB Mode
ⓒ 2007 by Panarex Electronics 34
Advertisement
Table of Contents
