Positioner Setting - Pansat 9000HD User Manual

High-definition digital satellite & terrestrial receiver

Table of Contents

22KHz control is automatically set for each LNB alternative or you can change it by yourself.

2.1.3 LNB Lo-Freq

If the required LNB frequency is not available, select "Standard" and then input the frequency manually using the

numeric keys.

2.1.4 22Khz

In case you are using a dual LNB or two antennas connected to a 22KHz tone switch box, make 22KHz tone switch

"ON" or "OFF" to select an LNB or an antenna.

2.1.5 DiSEqC

• DiSEqC 2X1 & 4X1 are supported.

• Select the port connected to the LNB or LNBF.

2.1.6 Positioner Setting

It is used to set the DiSEqC 1.2 or USALS motor.

If you have no positioner equipment, select "Disable". Otherwise, you can select either DiSEqC 1.2 or USALS.

1) DiSEqC 1.2 (manual operation)

(1) Current position

Select the position number by using

(2) Movement

Select East / West by using

(3) Store

Please select "Store" and the current position will be saved.

(4) East Limit Set

Move the position to the most eastern position and press OK then East Limit is stored.

(5) West Limit Set

Move the position to the most western position and press OK then West Limit is stored.

(6) Limits Disable

Select Disable limits by using OK key

(7) Go to reference

Select go to reference by using OK key

If the motor shifted to one side(usually it happens after used), you can resynchronize by using DiSEqC 1.2 "go to

reference" and then go back to programmed mode.

keys (#0~#26:default define, #27~#49: user define)

◀ ▶

keys

◀ ▶

Table of Contents