Table of Contents
Advertisement
2.1 Antenna Setup
In this section you could know how to operate LNB set-up.
2.1.1 Satellite
• When you adjust the LNB set-up,
you select the satellite using OK key.
• Adjust LNB type , LNB Lo-Freq, 22kHz, DiSEqC, LNB power, TP, Positioner Setting.
• You can cancel the satellite you chose using EXIT key.
2.1.2 TP
Select a specific transponder by using the
2.1.3 LNB type
Select LNB type using
◀ ▶
There are 5 LNB alternatives.
• Universal 1 (9750MHz & 10600 MHz)
• Universal 2 (9750MHz & 10750 MHz)
• Single-SL (5150MHz & 5750 MHz)
• Single-SH (5150MHz & 5750 MHz)
• Standard for USA (10750 or 11250)
• Single Stack (10750(V) or 11250(H))
22KHz control is automatically set for each LNB alternative
2.1.4 LNB Lo-Freq
If the required LNB frequency is not available, select "Standard" and then input the frequency manually using the
numeric keys.
2.1.5 22Khz
In case you are using a Dual LNB or two antennas connected to a 22KHz tone switch box, make 22KHz tone switch
"ON" or "OFF" to select an LNB or an antenna.
2.1.6 DiSEqC
• DiSEqC 1.0, 1.2, 1.3 (STAB USALS) is compatible
• DiSEqC 2X1 & 4X1 is usually available.
2.1.7 Positioner Setting
It is used to set the DiSEqC 1.2 motor & USALS
If you have no positioner equipment, select "Disable". Otherwise, you can select either DiSEqC 1.2 or USALS.
keys.
◀ ▶
keys.
or you can change it by yourself.
14
Advertisement
Table of Contents
