Table of Contents
Advertisement
2
Determine the section on tape to be imported.
There are four ways to determine the section to be
imported.
• While playing the tape and monitoring the proxies
on the left side of the display or the monitor
connected to the VTR, click the MarkIn button at the
point that you want to specify as the IN point. Then,
click the MarkOut button at the point that you want
to specify as the OUT point.
• Enter the IN point timecode in the IN box, and enter
the OUT point timecode in the OUT box.
• Enter the IN point timecode in the IN box, and enter
the duration of the section to be imported in the DUR
box.
• Click the MarkIn button in the IN box at the point
you want to specify as the IN point. Then enter the
duration of the section to be imported in the DUR
box.
To enter timecode in drop frame mode
Enter a comma "," or a semi-colon ";" as the delimiter
between the seconds and the frames, instead of a colon
":".
Specifying IN/OUT points by loading an
EDL
The section to be imported can be specified by loading an
EDL created using an external editor.
Click the Browse... button at the right of the EDL box in
the VTR CONTROL tag display and specify the EDL that
is stored on a disk of the web client or external media, and
then click the LOAD button.
The EDL formats that can be loaded are CMX, GVG, and
BVE-9000/9100.
To put handles to the IN/OUT point positions by
frame
Enter the value (frames) in the HANDLES box. According
to the entered value, the IN point shifts in the reverse
direction and the OUT points shifts in the forward
direction compared to the original positions of the IN/OUT
points in the EDL.
20
Importing Files
Loading a clip sequence from the export
log display
For details, see "To load a clip sequence from the export
log display" on page 28.
Loading a clip sequence from Tele-File
By selecting the clip from the clip list stored in the Tele-
File label on the cassette tape, the clip sequence can be
loaded directly to the clip list.
Click the Tele-File button at the right of the EDL box in the
VTR CONTROL tag display to open the CASSETTE tag
display, and select the clip to be loaded from the clip list
stored to the Tele-File label on the cassette tape. Then,
select "Direct to Import List" for the FILE TYPE box, and
then, click the SAVE button.
For details see "Outputting Tele-File Information" on
page 34.
Checking the clip list and transposing
clips
After specifying the IN/OUT points, double-click the
proxy to register the section between the IN and OUT
points in the clip list. Registered clips can be viewed in the
CLIP LIST area of the VTR CONTROL tag display.
Registered clips can be transposed through drag-and-drop
operations.
When multiple clips are registered, importing starts from
the top of the list and continues to the bottom of the list.
To clear the contents of the clip list
Click the CLEAR button in the CLIP LIST area of the
VTR CONTROL tag display.
To remove a specific clip
Double-click the clip.
To leave out the clips with the same reel name
While holding down the Shift key and the Ctrl key (or the
Alt key) on the keyboard, double-click one of the
registered clips. The clips with the same reel name remain
and all other clips are deleted.
The reel name is indicated above the IN/OUT/DUR boxes
in the CLIP LIST area.
For uncompressed data
The VTR CONTROL tag display opens as shown below.
Advertisement
Table of Contents
