Electrolux EOG1102COX User Manual page 9

different one, which is necessary for the
type of gas you use.
Refer to "Technical data" chapter.
6. Assemble the burner in a reverse
sequence.
Replace the gas type sticker near the gas
supply ramp with the one related to the new
gas type.
The gas oven burner does not need any
primary gas regulation.
Make sure that the gas supply
pressure of the appliance is in
line with the recommended
values.
If the supply gas pressure is
changeable or different than the
necessary pressure, you must fit
an applicable pressure adjuster
on the gas supply pipe.
3.5 Minimum level adjustment of
the oven burner
1. Disconnect the oven from the mains.
2. Turn the knob for the gas control to the
minimum position and remove it.
3. Adjust the adjustment screw (A) with a
thin-bladed screwdriver.
Change of the
type of gas
From natural gas
to liquid gas
A
Adjustment of
the adjustment
screw
Fully tighten the
adjustment screw
in.
From liquid gas to
natural gas
4. Attach the knob for the gas control.
5. Connect the oven to the mains.
WARNING!
Only put the mains plug into the
mains socket when all parts are
back into their initial position.
There is a risk of injury.
6. Light the gas oven burner.
Refer to "Daily use" chapter.
7. Set the knob for the gas control to the
maximum position and let the oven heat
for at least 10 minutes.
8. Turn the knob for the gas control from the
maximum to the minimum position.
Control the flame. If the flame goes out, do
the procedure again. There must be a small
regular flame on the oven burner crown.
The manufacturer objects liability if you
do not obey to this safety measures.
3.6 Building In
Only set up the appliance in a kitchen or in a
kitchen-dining room. Do not set up the
appliance in a bathroom or a bedroom.
You can install the appliance "built-in" or
"built-under". The dimensions of the built-in
cabinet must agree with the related
illustrations.
Release the ad‐
justment screw
approximately 1/3
of a turn.
ENGLISH 9