Table of Contents
Advertisement
page, please refer to page
8.7 Network Configurations
The device supports two kinds of network connection modes: wired network connection
and wireless network connection. This section describes the wired network connection.
For wireless network connection, refer to
The device relies on IP network connection to provide service. Unlike traditional phone
system based on a circuit switched wire technology, IP devices are connected to each
other over the network and exchange data in packet basis based on the devices' IP
address.
To enable this phone, you must first correctly configure the network configuration. To
configure the network, users need to find the phone function menu button [Settings] >>】
Advanced]>> [Network] >> [Ethernet].
NOTICE! If user saw a
screen, it means the network cable was not correctly connected to the device's
network port. Please check the cable is connected correctly to the device and to
the network switch, router, or modem.
The device supports IPv4.
There are two common IP configuration modes about IPv4.
Dynamic Host Configuration Protocol (DHCP) – This is the automatic configuration
mode by getting network configurations from a DHCP server. Users need not to
configure any parameters manually. All configuration parameters will be getting
from DHCP server and applied to the device. This is recommended for most users.
Static IP Configuration – This option allows user to configure each IP parameters
manually, including IP Address, Subnet Mask, Default Gateway, and DNS servers.
This is usually used in an office environment or by power users.
The device is default configured in DHCP mode.
Please see
10.7.2.1 network Settings
8.8 SIP Configurations
A line must be configured properly to be able to provide telephony service. The line
configuration is like a virtualized SIM card. Just like a SIM card on a mobile phone, it
stores the service provider and the account information used for registration and
11 Web
configurations.
10.5 wi-fi.
'WAN Disconnected' icon flashing in the middle of
for detailed configuration and use.
30
Advertisement
Table of Contents
