V.logic camera interface compatible with the e-series bmw and mini with navigation system or radio and 6.5” or 8.8” monitor with 4pin hsd lvds connector (20 pages)
Service / Support ........................4 Shipment ............................. 4 Product Description ........................5 Installation of the harness MD-VW03 in Golf 5, Touran, Passat ........... 5-7 Installation of the harness MD-VW03 in VW Touareg and T5 ..........8-9 Function and control ......................10-11...
Safety Instructions: 1. Read through mounting guidelines: Please read through all safety instructions and handling directions intently before installation and start up of the device. 2. Keep mounting guidelines: Keep the instruction manual and safety instructions for potential further reference. 3.
Date of purchase, your name and address, item number and the type of your vehicle. Shipment: Harness MD-VW03 Manual iPod® ist ein eingetragenes Markenzeichen der Apple Computer, Inc. iPod® is a registered trademark of Apple Computer, Inc.
Product Description: Article: MD-VW03 Harness for Multimedia interface “MULTI200” Features: For use with the following navigation systems: VW with MFD3 / RNS510: Golf5, Passat, Touran Touareg, T5 Pin assignment of the harness: Color/connector: Signal: 26pin AMP connector: To the MFD3 / RNS510...
Page 6
2. Remove the Quadlock plug form the navigation system. Connect the 26pin AMP connector from the harness to the navigation. 3. Connect the blue cable from the harness to pin 10 (CAN LOW) at the Quadlock plug and the yellow cable to pin 9 (CAN HIGH).
Page 7
6. To use the rear view camera function you have to open the interface. As seen on the right side you have to close the connection with the middle jumper. Connect the video signal of the aftermarket rear view camera to the "R-CAM IN" plug. The green cable of the harness can be used to supply power (+12V) to the rear view camera.
Instructions for VW Touareg and T5: Please remember to switch off the ignition prior to installing this interface. 1. Loosen the navigation system from its mounting points and remove it from the dash. You will need a dedicated tool which isn’t supplied. 2.
Page 9
5. Connect the Video / Audio RCA cables (not included) to the plugs (AV1 / AV2) at the interface and the video sources. 6. Connect the 14pin Molex connector and the 18pin AMP connector to the interface. You can also connect an external monitor to the "VIDEO OUT"...
Function and control: Activation: To activate the device control functions you have to press „MEDIA“ on the left side and then „VIDEO“ on the touch screen. The MFD3 / RNS-510 is now in TV mode. Device assignment: Press „Extras“ and then „V-Text“. Now press „Seite“...
Need help?
Do you have a question about the MD-VW03 and is the answer not in the manual?
Questions and answers