Identification Marking - JUMO EM Series Operating Manual

You will find the Declarations of conformity at www.jumo.en.
• Products
• Temperature
• Monitor/Limiter
• Electromechanical
• Panel-mounting thermostats 602021
• Documentation
• Declaration of conformity/White Paper
Ask for them to be sent.
CAUTION!
Failure of the device
Cutting or kinking the capillary of the device leads to permanent failure of the functions!
Physical and toxicological properties of the expansion fluid that may escape in the event of a system
fracture.
Control range Dangerous
with end of scale reactions
< 200 °C No
≥ 200 °C No
≤ 350 °C
> 350 °C No
≤ 500 °C
NOTE!
At present, there is no restrictive statement from the health authorities concerning any danger to health
over short periods and at low concentration, e.g. after a fracture of the measuring system.
2.3

Identification marking

Depending on the version (for details see nameplate):
Fire and explosion hazard
Ignition Explosion limit
temperature
355 °C 0.6 to 8 % v/v
490 °C -
No No
2 Introduction
Water Toxicological data
contamination
Irritant
Yes Yes
Yes Yes
No No
®
Danger Toxic
to health
See note No
See note No
No No
7