Casio XJ-350 User Manual page 44

Projection Operations
Auto Input Source Selection
When you turn on the projector, it checks the status of each input source (whether or not
the input source is sending a signal) in the sequence shown below. It automatically selects
the first input source it finds that is sending an input signal, and projects the applicable
image.
RGB terminal input
(RGB/Component)
If the RGB input terminal is connected to a computer and the S-VIDEO input terminal is
connected to a video deck and signals are being supplied by both, for example, the projector
automatically selects RGB input when it is turned on. The currently selected input source
name is shown in the upper right corner of the projection screen.
If the projector does not find any input signal, the message "No signal input" appears in
place of the input source name.
Whether the displayed input source name shows [RGB] or [Component] depends on the
current "Input Settings
projector's setup menu.
If the input source name shows this:
RGB
Component
For information about configuring setup menu settings, see "Using the Setup Menu" on
page 61. For information about component video, see "Connecting to a Component Video
Output Device" on page 37.
Note that the projector does not select the input source automatically when "Off" is
selected for the "Option Settings
menu.
VIDEO terminal input
(VIDEO)
RGB Input" (page 85) setting that is configured on the
It means this input is selected:
RGB
Component video
Auto Input Detect" (page 89) setting on the setup
44
S-VIDEO terminal input
Input source name
RGB
(S-VIDEO)