Adjusting And Changing The Settings - Sony LMD-2735MD Manual

Input Name
Power Supply
HDCP Setting
Auto Input Select
Control Lock
OSD Setting
Power On Setting
Power Save
Serial Remote
Ethernet Setting
Custom Button
Panel Display
Monitor Information
� Initial Setup
Language
Port A Input Select
Port B Input Select
Pattern Skip
PIP / POP
Custom Button
Auto Input Select
� Preset
Load User Setting
Save User Setting
User Name
Load Default
The Color Tone Adjustment menu is used to adjust
picture quality for each input.
You need to use the measurement instrument to adjust
the color temperature.
Recommended: Konica Minolta color analyzer CA-310
0
System Configuration

Adjusting and changing the settings

@ Color Tone Adjustment menu
@ColorToneAdJunment
0��8
l = ma
2.2
0�1001
so
IPha,c
0�1001
so
lchfoma
0�1001
so
18rlghtnen
0�1001
leo.-inan
80
Page 1/3
2
41
Adjustment Using the Menus
1
Gamma Select the ap � rop � i � te g �! !?1 od ;
from among 1.8,
"2.6;' "DICOM. "
"DICOM" is for reference, not
diagnostic, purposes only.
Phase Adjusts color tones. Tue higher the
setting, the more greenish the picture.
The lower the setting, the more purplish
the picture.
Chroma Adjusts color intensity. Tue higher the
setting, the greater the intensity. Tue
lower the setting, the lower the
intensity.
Brightness Adjusts brightness.
Contrast Adjusts contrast.
Color Temperature Select the color temperature from
among "D56;' "D65;' "D93:'
If the setting is changed, Gain R/G/B
Offset and Bias R/G/B Offset are
restored to O respectively.
Gain R Offset Adjust color temperature in detail, and
Gain G Offset color balance (Gain).
Gain B Offset
Bias R Offset Adjust color temperature in detail, and
Bias G Offset color balance (Bias).
Bias B Offset
Mono Sets the display to a monochrome
picture. Set to "On" for a monochrome
picture, set to "Off' for a normal
(chromatic) picture.
Sharpness H Adjusts the horizontal sh
higher the setting, the sharper the
picture. The lower the setting, the softer
the picture.
Sharpness V Adjusts the vertical sharpness. The
higher the setting, the sh
picture. The lower the setting, the softer
the picture.
RGB Range Sets the RGB signal range. Select from
among "Auto:' "Limited;' "Full:' If you
set to "Auto, " t
"Limited" when inputting video signal,
and "Full" wheo inputting PC signals.
RGB/YPbPr Sets the input signal of the HDlS
connector. Select from arnong "RGB;'
"YPbPr. "
Select "RGB" to display PC signals.
Sync Detect Sets detectioo of the syoc signal of the
input signal. Select from among "Auto, "
"Interna!;' "Exteroal. " If you set to
"Auto;' external synchronization is
prioritized. If there is no ex:ternal
syochronizatioo, interoal
syochronization is set.
Submenu Setting
l@M
l@M
2.0, 2.2, 2.4,
ness. Tue
er the
is item is set to
arp
arp
h