Kiloview S2 HEVC User Manual page 40

Setting parameters means the following (It can be set according to the network
situation, and select the default configuration generally):
Handshake mode: Caller, Listener and Rendezvous. The Caller and Listener
➢
mode are commonly used. In the LAN, the encoder and the decoder can use
the Caller and the Listener at will. After one end uses the Caller mode, the other
end uses the Listener mode. In Internet transmission, the one end with the
public IP address will be the Listener;
Public IP address: Set IP address of the receiver;
➢
Port: Set the listening port corresponding to the receiver;
➢
Transport delay: Set it based on the performance of the current network, the
➢
delay value can be set on both the SRT source device and the SRT target device.
The final SRT transmission delay will be the larger one of the two values;
SRT streaming ID: SRT streaming identification;
➢
Encryption mode: AES-128, AES-192, AES-256;
➢
AES key: Encryption key can be 10-32 letters or numbers combination;
➢
Bandwidth overhead: It is set as the percentage value based on network link
➢
35