Cloud Connectivity - EVBox Smart Charging Installation Manual

6. Cloud connectivity

During start-up, the EVBox Smart Charging Wi-Fi Connect or Genius will check the internet
connectivity used.
Option A – Connection through Ethernet: The internet connection is established automatically.
The LED on the Wi-Fi Connect or Genius shows a steady green when ready.
Option B – Connection using Wi-Fi:
• The Wi-Fi Connect or Genius opens its hotspot allowing the configuration of the Wi-Fi network
and password.
• The Wi-Fi Connect or Genius LED shows yellow when the hotspot can be selected in the list of
available Wi-Fi networks on your smartphone.

Note: It can take few minutes before the hotspot is open.
• Make sure your mobile data (3G/4G) is switched OFF on your smartphone before proceeding.
• For more details about the Wi-Fi properties, refer to Addendum 2.
Resetting the Wi-Fi
For connecting the Wi-Fi Connect or Genius to another Wi-Fi network or for
changing the authentication password, select in the Smappee Energy Monitor
app Settings > Your Smappee Monitors > Smart Charging > Infinity components
> Smappee Wi-Fi Connect or Genius > Change your Wi-Fi settings and follow the
steps in the app.
Genius reset button:
Press using a small pin.
Wi-Fi Connect reset button:
Press using a small pin.
Factory reset
Perform a factory reset when you re-install a Smart Charging monitor at another
location or when you need to start with the factory settings.
Press the reset button of the Wi-Fi Connect or Genius with a small pin until the LED
shows blue (approximately 20 seconds). During this process, the Wi-Fi Connect or
Genius LED first shows purple, then yellow, then no colour, and finally blue.
25