Table of Contents
Advertisement
MAINTENANCE AND SERVICE
Make sure the equipment is stable and not likely to tip over during maintenance and service.
Disconnect the trailer from the vehicle while the defects are fixed.
Replace damaged and worn parts immediately to reduce the risk of injury. Use only spare
parts with equivalent performance to reduce the risk of damage and failure. Perform mainte-
nance, servicing and inspections according to the recommendations.
Regularly check the condition of the trailer. Tighten wheel bolts and nuts as necessary. If cracks,
twisting, bending, glitches or fatigue is detected, stop using the equipment immediately and
repair the equipment. Avoid the use of the tool at lower temperatures than -20C and higher
temperatures than +30C.
•
Always check the air pressure of the wheels, the air pressure shall always be about 25 psi
(about 1 bar). Never pump wheels more than necessary
•
Check the wheel axle and wheel bearings, lubricate them regularly.
•
Clean the trailer carefully before storing it especially when it will be stored a longer pe-
riod. When stored for a long period it is recommended that the vehicle is stored under a
roof or covered with tarpaulin.
•
Check all bolts and nuts are tightened after maintenance and service.
•
Always test the machine before work is started.
Warning!
RECYCLING
Disposal of the product, the machine should be disassembled and transported to the munici-
pality recycling station. Contact your municipality for further information.
8
Never use a tool or product
with defect safety equipment.
Advertisement
Table of Contents
