HMS Premium BE6000 Manual Instruction page 40

Treadmill adjustment
1. Before connect power, service or professional inspect if voltage is suitable, and if three-
core plug grounded wire is connected. Using hand to pull the belt, inspect if rotation is
flexible and no noise.
2. Connect power, press Start key, treadmill will run slowly, inspect if belt and computer are
normal.
3. Press incline +/- key, inspect treadmill rotation and display. If the belt is deviation, you must
stop it to adjust belt according daily maintenance
4. Pressing emergency stop key or pull out safety key on running treadmill, it will stop
immediately. Rotating the emergency stop key to reset or insert safety key, can restart
treadmill.
5. Press Stop key, the treadmill stop to running, waiting incline back to zero class, turn off the
power
Treadmill can use after all the install adjustment is finished.
3.
Two feet stand on two side of belt, put the other side clip from safety key to clip to clothes. (see
figure)
4.
Press Start key, the treadmill will run slowly. You can step
on belt slowly.
5.
Press speed+ key, the belt speed will gradually increase,
you can see the speed data from computer, after run is
suitable, you can let go handrail to run.
6.
When stop running, should gradually slow, and run 2-3
minutes in slow speed, put the heart and breathe back to
normal.
7.
At the end of run, you can reduce belt speed to the
lowest, and the treadmill will stop when pressing stop
key.
8.
If it is too late to reduce speed and lose balance when high speed running, you can press and