Assembly Instruction - HMS Premium BE6000 Manual Instruction

Assembly instruction

Please make sure there's enough space to install the treadmill and recommend 2 persons to install
it.
WARNING: Don't insert the power wire until the treadmill was fully assembled.
Assembly tips:
1. In order to avoid instruction mistake, do not tighten bolt completely until the whole treadmill
assembly is finished
2. This treadmill packaged for 2 cartons.

#1 carton is main frame.

#2 carton is Handlebar and controller.
1. Assembling left upright tube
Install the Left upright tube (4) to base support (8) using 2pcs half-round bolt 8X55 (A10), 2pcs half-
round bolt 8X65 (A11) by side and 1pcs half-round bolt M8X20 (A7), 1pcs Flat washerφ8 (C1) by end.
(See figure 1)
2. Assembling right upright tube

Connect the Signal wire from
right upright
corresponding wires from
frame

Install the Right upright tube
(5) to base support (8) using
2pcs half-round bolt 8X55
(A10), 2pcs half-round bolt
8X65 (A11) by side and 1pcs
half-round bolt M8X20 (A7),
1pcs Flat washerφ8 (C1) by end. (See figure 2)
tube to