Battery Type; Storage Recommendations; Assembly And Adjustments - Stanley SCD12 Instruction Manual

ENGLISH (
Original Instructions)
In most instances, shipping a STANLEY battery pack will
be excepted from being classified as a fully regulated Class
9 Hazardous material. In general, the two instances that
require shipping Class 9 are:
1. Air shipping more than two STANLEY lithium-ion
battery packs when the package contains only battery
packs (no tools), and
2. Any shipment containing a lithium-ion battery with an
energy rating greater than 100 watt hours (Wh). All
lithium-ion batteries have the watt hour rating marked
on the pack. Regardless of whether a shipment is
considered excepted or fully regulated, it is the shipper's
responsibility to consult
Regardless of whether a shipment is considered excepted
or fully regulated, it is the shipper's responsibility to consult
the latest regulations for packaging, labeling/marking and
documentation requirements.
Transporting batteries can possibly cause fire if the battery
terminals inadvertently come in contact with conductive
materials. When transporting batteries, make sure that
the battery terminals are protected and well insulated from
materials that could contact them and cause a short circuit.
The information provided in this section of the manual is
provided in good faith and believed to be accurate at the
time the document was created. However, no warranty,
expressed or implied, is given. It is the buyer's responsibility
to ensure that its activities comply with the applicable
regulations.

BATTERY TYPE

The SCD12 operates on a 12V Max battery pack.

STORAGE RECOMMENDATIONS

1. The best storage place is one that is cool and dry
away from direct sunlight and excess heat or cold. For
optimum battery performance and life, store battery
packs at room temperature when not in use.
2. For long storage, it is recommended to store a fully
charged battery pack in a cool, dry place out of the
charger for optimal results.
Note: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be
recharged before use.
LABELS ON CHARGER AND BATTERY PACK
In addition to the pictographs used in this manual, the labels
on the charger and the battery pack may show the following
pictographs:
Read instruction manual before use.
See Technical Data for charging time
28
Battery charging
Battery charged
Battery defective
Hot/Cold pack delay
Do not probe with conductive objects
Do not charge damaged battery packs
Do not expose to water
Have defective cords replaced immediately
Charge only between 4 ˚C and 40 ˚C
Only for indoor use
Discard the battery pack with due care for
the environment
Charge STANLEY battery packs only with
designated STANLEY chargers.
SC121/SC122
Do not incinerate the battery pack

ASSEMBLY AND ADJUSTMENTS

Warning! Prior to assembly and adjustment, always
remove the battery pack. Always switch off the tool before
inserting or removing the battery pack.
Warning! Use only STANLEY battery packs and
chargers.
Inserting and removing the battery pack from
the tool (Fig. C)
Warning! To reduce the risk of serious personal injury,
place the forward/reverse button in the lock-off position or
turn tool off and disconnect battery pack before making
any adjustments or removing/installing attachments or
accessories. An accidental start-up can cause injury. Note:
Make sure your battery pack (7) is fully charged.