Troubleshooting - Stanley SCD12 Instruction Manual

PROBLEM
Unit will not start.
Unit starts immediately upon inserting
battery.
Battery pack will not charge
Unit shuts off abruptly.
TROUBLE SHOOTING
POSSIBLE CAUSE
Battery pack not installed properly.
Battery pack not charged.
The switch has been left in the "on"
position.
Battery pack not inserted into charger.
Charger not plugged tin.
Surrounding air temperature too hot
or too cold.
Battery pack has reached its maximum
thermal limit.
Out of charge. (to maximize the life
of the battery pack it is designed to
shutoff abruptly when the charge is
depleted.)
ENGLISH (
Original Instructions)
POSSIBLE SOLUTION
Check battery pack installation.
Check battery pack charging
requirements.
The switch must be moved to "off"
to prevent the tool from immediately
starting when battery is inserted
Insert battery pack into charger until
LED lights.
Plug charger into a working out let.
Refer to "Important Charging Notes"
for more details.
Move charger and battery pack to a
surrounding air temperature of above
40 degrees F (4,5°C) or below 105
degrees F (+40,5°C).
Allow battery pack to cool down.
Place on charger and allow to charge.
33