Specific Safety Instructions For Lithium Ion (Li-Ion); Important Safety Instructions For All Battery Packs - Stanley SCD12 Instruction Manual

Hide thumbs Also See for SCD12:
Table of Contents

Advertisement

Available languages

Available languages

2. Insert the battery pack (7) into the charger. The
charging light will blink continuously indicating that the
charging process has started.
3. The completion of charge will be indicated by the
charging light remaining ON continuously. The pack
is fully charged and may be used at this time or left in the
charger.
Note: To ensure maximum performance and life of Li-Ion
batteries, charge the battery pack fully before first use.
Charging process
Refer the table below for the state of charge of the battery
pack.
State of charge
charging
––
––
–– ––
––
fully charged
––––––––––––––––––––
––
–– ––
–––––––
hot battery
––
–– ––
HOT/COLD PACK DELAY
The SC122 (SC121) charger have a hot/cold delay
feature. When the charger detects a battery that is hot, it
automatically delays charging until the battery has cooled.
When the charger detects a battery that is cold, it
automatically delays charging until the battery has warmed.
The red light will continue to blink and can't start to charging
procedure . Once the battery has cooled ,the charger will
resume the charging procedure.
Stanley Li-Ion tools are designed with an Electronic
Protection System that will protect the battery against
overloading, overheating or deep discharge.
The tool will automatically turn off if the Electronic Protection
System engages. If this occurs, place the Li-Ion battery on
the charger until it is fully charged.
LI-ION BATTERY PACKS ONLY
Li-Ion batteries are designed with an "Electronic
Protection System" that will protect the battery against
overloading,overheating or deep discharge.
The tool will automatically turn off if the "Electronic
Protection System" engages. If this occurs, place the Li-Ion
battery on the charger until it is fully charged.
READ ALL INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
FOR ALL BATTERY PACKS
When ordering replacement battery packs, be sure to
include catalog number and voltage.
The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read the safety
instructions below. Then follow charging procedures outlined.
f Do not charge or use battery in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust. Inserting or removing the battery
from the charger may ignite the dust or fumes.
SC121
SC122
red blink
green blink
red light
green light
yellow light + red blink
X
X
red blink
f Never force battery pack into charger. Do not
modify battery pack in any way to fit into a non-
compatible charger as battery pack may rupture
causing serious personal injury.
f Charge the battery packs only in STANLEY chargers.
f DO NOT splash or immerse in water or other liquids.
f Do not store or use the tool and battery pack
in locations where the temperature may reach
orexceed 40 ˚C (105 ˚F) (such as outside sheds or
metal buildings in summer).
Warning! Never attempt to open the battery pack for any
reason. If battery pack case is cracked or damaged, do not
insert into charger. Do not crush, drop or damage battery
pack.
Do not use a battery pack or charger that has received a sharp
blow, been dropped, run over or damaged in any way (i.e.,
pierced with a nail, hit with a hammer, stepped on). Electric
shock or electrocution may result. Damaged battery packs
should be returned to service centre for recycling.
Caution: When not in use, place tool on its side on
a stable surface where it will not cause a tripping or
falling hazard. Some tools with large battery packs will
stand upright on the battery pack but may be easily knocked
over.
SPECIFIC SAFETY INSTRUCTIONS
FOR LITHIUM ION (Li-Ion)
f Do not incinerate the battery pack even if it is
severely damaged or is completely worn out. The
battery pack can explode in a fire. Toxic fumes and
materials are created when lithium ion battery packs
are burned.
f If battery contents come into contact with the skin,
immediately wash area with mild soap and water.
If battery liquid gets into the eye, rinse water over the
open eye for 15min or until irritation ceases. If medical
attention is needed, the battery electrolyte is composed
of a mixture of liquid organic carbonates and lithium
salts.
f Contents of opened battery cells may cause
respiratory irritation. Provide fresh air. If symptoms
persists, seek medical attention.
Warning! Burn hazard. Battery liquid may be flammable
if exposed to spark or flame.
TRANSPORTATION
STANLEY batteries comply with all applicable shipping
regulations as prescribed by industry and legal standards
which include UN Recommendations on the Transport of
Dangerous Goods; International Air Transport Association
(IATA) Dangerous Goods Regulations, International
Maritime Dangerous Goods (IMDG) Regulations, and
the European Agreement Concerning The International
Carriage of Dangerous Goods by Road (ADR). Lithium-
ion cells and batteries have been tested to section 38.3 of
the UN Recommendations on the Transport of Dangerous
Goods Manual of Tests and Criteria.
ENGLISH (
Original Instructions)
27

Advertisement

Table of Contents
loading

This manual is also suitable for:

Scd12s2kScd121s2k

Table of Contents