Charging The Battery - Stanley SBH20 Original Instructions Manual

ENGLISH
(Original instructions)
LABELS ON TOOL
The following symbols are shown on the tool along with the
date code:
Warning! To reduce the risk of injury, the user must
read the instruction manual.
Always wear safety goggles
Always wear safety hearing protection
POSITION OF DATE CODE
The Date Code, which also includes the year of manufacture,
is printed into the housing.
Example:
2017 XX JN
Year of manufacturing
Additional safety instructions for batteries and
chargers
Batteries
• Never attempt to open for any reason.
• Do not expose the battery to water.
• Do not store in locations where the temperature may
exceed 40 °C.
• Charge only at ambient temperatures between 10 °C and
40 °C.
• Charge only using the charger provided with the tool.
• When disposing of batteries, follow the instructions given in
the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Chargers
• Use your Stanley charger only to charge the battery in the
tool with which it was supplied. Other batteries could burst,
causing personal injury and damage.
• Never attempt to charge non-rechargeable batteries.
• Have defective cords replaced immediately.
• Do not expose the charger to water.
• Do not open the charger.
• Do not probe the charger.
The charger is intended for indoor use only.
Read the instruction manual before use.
6
Electrical safety
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains voltage
corresponds to the voltage on the rating plate. Never
attempt to replace the charger unit with a regular
mains plug.
• If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Stanley Service Centre in
order to avoid a hazard.
FEATURES
This appliance includes some or all of the following features.
1. Trigger Switch
2. Forward/Reverse Button
3. Torque Adjust Collar
4. Dual Range Gear Selector
5. Keyless Chuck
6. Battery
7. Battery Release Button
8. LED Work Light
9. Bit Tip Holder
Use
Warning! Let the tool work at its own pace. Do not overload.

CHARGING THE BATTERY

The battery needs to be charged before first use and whenever
it fails to produce sufficient power on jobs that were easily done
before. The battery may become warm while charging; this is
normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging tempera-
ture: approx. 24 °C.
Note: The charger will not charge a battery if the cell tempera-
ture is below approximately 10 °C or above 40 °C.
The battery should be left in the charger and the charger will
begin to charge automatically when the cell temperature warms
up or cools down.
• Plug the charger into an appropriate outlet before inserting
the battery pack.
• Insert the battery pack into the charger.
The green LED will flash indicating that the
battery is being charged.
The completion of charge is indicated by the
green LED remaining on continuously.
The pack is fully charged and may be used at
this time or left in the charger.