Table Of Contents - Label NEPTIS PLUS Installation Manual

TABLE OF CONTENTS

GENERAL SAFETY WARNINGS
GENERAL SAFETY OBLIGATIONS
1) DESCRIPTION OF THE MODELS
2) TECHNICAL SPECIFICATIONS
MECHANICAL SECTION
3) NEPTIS PLUS AUTOMATION COMPONENTS
4) PRELIMINARY CHECKS
5) TECHNICAL DRAWINGS
5.1) ASSEMBLY OF THE AUTOMATION ON THE TRANSOM FROM THE HINGE SIDE
5.2) ASSEMBLY OF THE AUTOMATION ON THE TRANSOM FROM THE HINGE SIDE
5.3) ASSEMBLY OF THE AUTOMATION ON THE TRANSOM FROM THE HINGE SIDE
5.4) ASSEMBLY OF THE AUTOMATION ON THE TRANSOM FROM THE SIDE OPPOSITE TO THE HINGE
5.5) ASSEMBLY OF THE AUTOMATION ON THE LEAF FROM THE HINGE SIDE
5.6) ASSEMBLY OF THE AUTOMATION ON THE TRANSOM FROM THE HINGE SIDE
6) MOVEMENT TRANSMISSION ARMS
6.1) SLIDE PULL ARM BDT2
6.3) SHORT SLIDE PULL ARM BDT2R55
6.4) SLIDING GUIDE FOR PULL ARM
6.5) BSS2 ARTICULATED PUSH ARM
6.6) EXTB-Z TAPERED PIN
6.7) EXTENSION FOR EXTB-Z TAPERED PIN
7) PREPARATION AND INSTALLATION OF THE AUTOMATION
7.1) TOOLS REQUIRED:
7.2) AUTOMATION CHECK
7.3) AUTOMATION INSTALLATION
7.4) CHOICE OF THE SPRING LOAD (FOR NEPTIS PLUS NB-LET, NB-LETB, NB-SLT, NB-SLTB AUTOMATIONS ONLY)
7.5) INSERTION OF THE ARM TAPERED PIN
7.6) SPRING RELEASE (FOR NEPTIS PLUS NB-LET, NB-LETB, NB-SLT, NB-SLTB AUTOMATIONS ONLY)
8) ARM REMOVAL
9) NEPTIS PLUS AUTOMATIONS WITH BATTERY (SLTB, LETB, SMTB MODELS)
10) SPRING PRE-LOAD RESETTING PROCEDURE (FOR SLT, SLTB, LET, LETB MODELS ONLY)
ELECTRONICS
11) ELECTRIC ARRANGEMENTS
12) ELECTRIC CONNECTIONS
13) PWB ELECTRICAL WIRING AND POWER SUPPLY MODULE
13.1) LOGIC CARD LCB
14) DIGITAL SELECTOR ET-DSEL - PURPOSE AND CONNECTIONS
15) SAFETY SENSORS
15.1) SAFETY SENSOR OA-EDGE T
15.2) FLAT SCAN SAFETY SENSOR
16) COMMISSIONING OF THE AUTOMATION (INITIAL SETUP)
16.1) FIRST START OF THE DIGITAL SELECTOR ET-DSEL
16.2) SERIAL COMMUNICATION SETTINGS
16.3) INITIAL SETUP
16.4) FUNCTIONAL TESTING
16.5) INPUT DIAGNOSTICS
4
4
5
5
6
7
8
8
9
10
11
12
13
14
14
15
15
15
16
16
17
17
17
18
18
18
18
19
20
21
22
23
24
26
26
27
27
27
28
28
28
29
31
31