Installation And Connection; Functional Diagram; Heat Pump Unit - Hayward ENERGYLINE INVERTER Series Installation & Operation Manual

3.1 Functional Diagram

Note: The swimming pool heat pump unit is sold without any treatment or filtration equipment. The components presented in the
diagram are spare parts to be supplied by the installer.

3.2 Heat Pump Unit

WARNING –
Placed under a shelter, the minimum required distances shown below must be respected in order to avoid any risk of air
» It is advised to install the unit on a dissociated cement
block or a mounting bracket designed for this use
and to set up the unit on the supplied rubber bushing
(fastenings and washers not supplied).
» The maximum installation distance between the unit
and the swimming pool is 15 metres.
» The total length of the piping to and from the unit is
30 metres.
» Insulate both the above ground and buried hydraulic
piping.
» The heat pump must be installed greater than 3.5 m
from the edge of the pool in accordance with AS/NZS
3000 Wiring Rules.
» Do not install the heat pump close to a heat source.
» For installation in snowy regions we recommend
sheltering the unit to avoid snow accumulating on the
evaporator.

3. INSTALLATION AND CONNECTION

Place the heat pump outdoors and away from any enclosed technical space.
recirculation and therefore a deficiency in the unit's overall performance.
USE ONLY HAYWARD® GENUINE REPLACEMENT PARTS Page 9