Hayward ENERGYLINE INVERTER Series Installation & Operation Manual page 2

Before installing or servicing this electrical equipment, turn OFF and ISOLATE power supply.
WARNING –
This manual contains important information about the installation, operation, and safe use of this heat
pump that must be transferred through to the end user of this product.
WARNING –
This product should be installed and serviced ONLY by a qualified professional.
WARNING –
All electrical wiring MUST be performed by a qualified electrical contractor, and must conform to Local/
State/Federal Government electrical regulations and the Latest Edition AS/NZS 3000 Wiring Rules.
WARNING –
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY
DO NOT PLAY WITH THE APPLIANCE.
CAUTION –
This heater is intended for use on permanently installed swimming pools and may also be used with hot
tubs and spas if so marked. Do NOT use with storable pools. A permanently installed pool is constructed in or on the ground
or in a building such that it cannot be readily disassembled for storage. A storable pool is constructed so that it is capable of
being readily disassembled for storage and reassembled to its original integrity. Though this product is designed for outdoor
use, it is strongly advised to protect the electrical components from the weather. Select a well-drained area, one that will not
flood when it rains. It requires free circulation of air for proper operation. Do not install in a damp or non-ventilated location.
WARNING –
Pool and spa components have a finite life. All components should be inspected frequently and replaced
at least every ten years, or if found to be damaged, broken, cracked, missing, or not securely attached.
electrical contractor, and must conform to Local/State/Federal electrical regulations and the Latest
Edition AS/NZ 3000 Wiring Rules. All electrical circuits must be supplied through a Residual Current
Device - RCD (Safety Switch), with a residual operating current not exceeding 30 mA. Hazardous
voltage can shock, burn and cause death or serious property damage.
WARNING –
The power supply to the heat pump must be supplied through an isolator switch located next to the
unit and complying with the Latest Edition of the AS/NZS 3000 Wiring Rules.
WARNING –
Hayward recommends that a Lightning Surge Protector Device (SPD) is installed on the feed circuit to
the heat pump by a qualified electrical contractor in accordance with AS/NZS 3000 Australian Wiring Rules Latest Edition.
WARNING –
To reduce the risk of electric shock replace damaged wiring immediately. Locate the power cord so that
it cannot be damaged by lawn mowers, hedge trimmers and other equipment.
WARNING –
Never operate the circulation system at more than 344 kPa (50 PSI) maximum.
Page 2
IMPORTANT SAFETY INSTRUCTIONS
Read and follow all instructions in this owner's manual and on
the equipment. Failure to follow instructions can cause severe
WARNING –
Risk of Electric Shock
USE ONLY HAYWARD® GENUINE REPLACEMENT PARTS
WARNING
injury and/or death
. All electrical wiring must be performed by a qualified