Operating From The Landing Station Controls - Savaria Telecab Owner's Manual

Operating from the Landing Station Controls

Figure 3 shows the different types of landing station (hall call) controls.
Figure 3
FLUSH MOUNT
To operate the Telecab from the landing station (hall call) controls:
1 Insert the key into the key switch and turn it clockwise to the operating
position. The key is in the operating position when it cannot be pulled out.
2 Apply constant pressure on the appropriate up/down button to move the
Telecab in the desired direction. Note that the Telecab will not move if the
door is open or if an object activates the underpan sensor or the floor plug
sensor.
3 When the cab reaches the landing, the door will unlock automatically for a
few seconds. You need to put a little pressure on the door in the closing
direction in order to release the latch mechanism. If you need to re-open the
door after the delay, turn the key on and press the call button again to
unlock the door.
4 To prevent unauthorized use of the lift, take the key out when the unit is not
in operation.
Part No. 000627, 09-m03-2010
Up
button
Key
switch
SURFACE MOUNT
Down
button
IN FRAME
Telecab Owner's Manual
9