Operation; Operating From The Cop Controls - Savaria Telecab Owner's Manual

8

3. OPERATION

Operating from the COP Controls

Figure 2 shows the car operating panel (COP) controls.
Figure 2
Up
To operate the Telecab from the COP controls:
1 Insert the key into the key switch and turn it clockwise to the operating
position. The key is in the operating position when it cannot be pulled out.
2 Apply constant pressure on the appropriate up/down button to move the
Telecab in the desired direction. Note that the Telecab will not move if the
door is open or if an object activates the underpan sensor or the floor plug
sensor.
3 When the cab reaches the landing, the door will unlock automatically for a
few seconds. You need to put a little pressure on the door in the closing
direction in order to release the latch mechanism. If you need to re-open the
door after the delay, turn the key on and press the call button again to
unlock the door.
4 To prevent unauthorized use of the lift, take the key out when the unit is not
in operation.
5 Pressing the Emergency Stop button during travel will stop the lift
immediately and activate the alarm. The Emergency Stop overrides the
landing station (hall call) controls. Pull the Emergency Stop out to return the
lift to normal operation.
6 Pressing the Alarm button during travel will activate the alarm.
7 Pressing the Light button will turn on the cab lighting.
Telecab Owner's Manual
Light
Key switch
Down
Alarm
Emergency stop
Part No. 000627, 09-m03-2010