Sony VENICE 2 Operating Instructions Manual page 50

50
3. Camera Operations: User Functions Screen
Assignable Button Function
setting
Iris Close (1/16 stop) Closes the lens iris.
6)
Press and hold to close the iris until fully
closed.
This function is available when an E-mount
lens with power iris is attached.
The setting is in 1/16 stop increments,
whereas the iris indication is in units of 1/3
stop increments.
1) Does not function if the key is pressed when Technical > Special Configuration > RM/RCP Paint Control (page 91)
is set to On in the full menu.
2) Also applied to the HDMI output if the HDMI output has the same output format as the Monitor output. You can
check the setting using Monitoring > Overlays/Frame Line > HDMI (page 79) in the full menu. The HDMI output is
the same as the Monitor output if HDMI is set to "Same as Monitor".
3) If the SDI output format is 1920×1080i, the focus magnifier function is off, and pressing the button performs no
function.
4) Switches to the same image as the main signal that is selected using Project > Basic Setting > Input Color Space
(page 72) in the full menu while the button is pressed.
5) Does not function if the key is pressed when an RM-B170 or other remote control unit is connected and Technical >
Special Configuration > RM/RCP Paint Control (page 91) is set to On in the full menu.
6) Does not function if the key is pressed when an RM-B170 or other remote control unit is connected.
7) Does not function if the key is pressed when Monitoring > Output Display > Flip Image (page 77) > H & V Flip in
the full menu is grayed out.
State after rebooting Functions that can be Assigned to Assignable Buttons 1 to 4
–
Assignable Button
setting
No Assign
SDI 1/2 Frame Line
SDI 3/4 Frame Line
SDI Overlay
Press&Hold for SDI12
Log
Press&Hold for SDI34
Log
Monitor Frame Line
Monitor Overlay
Press & Hold for Moni
Log
4)
Monitor Focus
Magnifier
Monitor Highlight
Clip Ind
Function
No assignment
Turns superimposition of frame lines on the
SDI 1/2 output image on/off.
Turns superimposition of frame lines on the
SDI 3/4 output image on/off.
Turns display of information on the SDI output
image on/off.
Disables the LUT applied to the SDI 1/2 output
image while the button is pressed, and sets
Log image quality without applying a LUT.
Disables the LUT applied to the SDI 3/4 output
image while the button is pressed, and sets
Log image quality without applying a LUT.
When the SDI 3/4 output and Monitor output
are linked, Press & Hold for Moni Log is also
enabled.
Turns superimposition of frame lines on the
Monitor output image on/off.
Turns display of information on the Monitor
output image on/off.
Disables the LUT applied to the Monitor
output image while the key is pressed for
normal image quality without applying a LUT.
When the SDI 3/4 output and Monitor output
are linked, Press&Hold for SDI34 Log is also
enabled.
When the HDMI output and Monitor output
are linked, HDMI output is also enabled.
Turns the focus magnifier function of the
Monitor output image on/off.
2) 3)
Turns the function that displays clipped
highlight areas in red on the Monitor output
1)
image on/off.
State after rebooting
–
Setting retained
Setting retained
Setting retained
Setting not retained
Setting not retained
Setting retained
Setting retained
Setting not retained
Setting not retained
Setting retained