Setting The Clock - Sony VENICE 2 Operating Instructions Manual

18
2. Preparation

Setting the Clock

When you use the unit for the first time, the
initial setup screen appears on the sub display
when the power is turned on.
Set the date and time of the built-in clock
using this display.
Time Zone
The value shows the time difference from UTC
(Coordinated Universal Time). Change the
setting if needed.
[Note]
When Time Zone is changed, the clock setting changes
according to the time difference.
Setting the Date and Time
Turn the MENU dial (page 10) to move the
cursor, then press the MENU dial to set each
menu item. When you press the MENU dial
when the cursor is on "Set," the setting display
disappears and the clock setting is completed.
After the initial setup screen disappears, you
can change Time Zone and date/time settings
using Maintenance > Clock Set (page 92) in
the full menu.
[Notes]
• If the clock setting is cleared because the backup
battery fully discharged when no power was supplied
(no battery pack and no DC IN connection), the initial
setup display will be displayed when you next turn
the unit on.
• While the initial setup display is shown, no other
operation, except turning the power off, is permitted
until you finish the setting for this display.