Sony VENICE 2 Operating Instructions Manual page 12

12
1. Overview: Location and Function of Parts
Rear
14
13
12
11
10
Air inlet
[Note]
Do not operate with the air inlet blocked.
1.
24V OUT connector (24 V DC output,
Fischer 3-pin)
24 V DC power supply output connector
(page 120).
The output voltage and maximum output
current of this connector vary depending on
the input voltage to the unit. The maximum
current includes the output current from
the 24V OUT connector on the front panel
(page 11).
11 V to 17 V input
Output voltage: 24 V
Maximum output current: 1.0 A
22 V to 32 V input
Output voltage: Same as the input voltage
Maximum output current: 2.0 A
2.
12V OUT connector (12 V DC output, LEMO
2-pin)
12 V DC power supply output connector
(page 120).
1
2
3
4
5
6
7
8
9
The output voltage and maximum output
current of this connector vary depending on
the input voltage to the unit.
11 V to 17 V input
Output voltage: Same as the input voltage
Maximum output current: 1.0 A
22 V to 32 V input
Output voltage: 16.8 V
Maximum output current: 1.0 A
3.
MONITOR OUT connector (BNC type)
HD SDI monitor signal output connector
(page 120).
4.
GENLOCK (genlock input) connector (BNC
type)
To genlock the unit to an external source or
to lock the timecode of the unit to an external
source, input an external reference signal.
Digital signal and analog signal input are
supported.
Digital signal: 1.5G HDSDI interlaced/
progressive signal
Analog signal: HD sync, SD sync
5.
TC IN (timecode input) connector (BNC
type)
To lock the timecode of the unit to an external
source, input a reference timecode signal.
6.
AUX connector (BNC type)
Outputs the timecode signal (page 120).
7.
Network connector (RJ-45)
Connect to a wired LAN network using a LAN
cable (not supplied) for remote control of the
unit (page 100).
8.
REMOTE (remote control) connector
(8-pin)
Connect to a remote control unit or other
external control device.
9.
12V/24V (DC power input) connector
(page 17)
DC power supply input connector for external
power supply to the unit. Supports 12 V and 24
V input voltages.
No. Signal
1 GND
2 NC
3 NC
4 DC IN (11 V to 17 V or 22 V to 32 V)
10.
Battery attachment terminal (page 17)
11.
SDI OUT 1 to 4 (serial digital output)
connectors (BNC type) (page 120)
12.
Battery pack mount (page 17)
13.
Battery release lever (page 17)
14.
HDMI OUT connector (page 120)