Casio Casiotone CT-S500 User Manual page 100

2.
Use CHG PART to select the part whose effect you want to change.
This causes the selected part's indicator ("U1", "U2", "L") to appear in the upper left of the display.
• Each press of CHG PART cycles between parts whose effect will be changed.
• Under initial default settings, effects are applied to the UPPER1 and UPPER2 parts only, so
even if you change the effect for the lower part, that effect is not applied. For information about
applying an effect to the lower part, see
EN-101.
3.
Rotate the dial to change the effect to apply to the part.
• You can select an effect value from 1 to 101.
• The "1:Tone" setting applies effects that depend on the selected keyboard tone. The knob
function also changes to the recommended parameters for that effect.
• After you rotate the dial once to select a value, you can change the value further using – and +.
• To go back to the previous screen, press BACK.
Applying the Effect You Want to a Tone (Active DSP)
"To change the part where the effect is
EN-99
applied" on page