Advertisement
There a 3 types of Pebbles supplied, SMALL ROUND, LARGE OVAL, LARGE
WARNING: DO NOT USE PEBBLES OTHER THAN THOSE SUPPLIED BY THE
MANUFACTURER OR A HAZARDOUS SITUATION MAY RESULT. WHEN INSTALLING
PEBBLES, ENSURE THAT THE BURNER HOLES ARE NOT OBSTRUCTED.
Obstructing any of the burner holes may result in poor performance.
SMALL
ROUND
Start at the back row left, fitting one
of the large irregular pebbles first,
1
then one large oval shaped pebble,
altenating as you go.
Check as you go to ensure the
burner ports are not obstructed by
4
the pebbles.
7
Continue fitting the small oval
pebbles across the middle row.
Adjust the spacing of the small
pebbles in the middle row until
10
they are relatively evenly spaced.
Keep the ignition area clear.
Australian Made Gas Log Fires
FITTING THE PEBBLES - LUMINAR
IRREGULAR. (See Images)
Make sure to keep the pebbles
clear of the burner ports and
2
continue alternating between the
irregular and oval pebbles.
The completed back row should
contain 7 of the irregular shaped
5
pebbles and 6 of the oval pebbles.
The completed middle row (below)
8
contains 15 small oval pebbles.
Start the bottom row, fitting the
large irregular pebbles between
11
the bars on the grate.
LARGE
OVAL
13
LARGE
IRREGULAR
Don't worry too much about
spacing between the pebbles yet.
3
They can be adjusted once all of
the pebbles have been fitted.
The middle row consists of the
smaller oval pebbles. Fit 2 from the
6
left side before the igniter, then 2
after the igniter as shown below.
Check that the ignition crossover
point (See below) and burner ports
9
are not obstructed.
Continue fitting the large irregular
pebbles. The completed bottom
12
row contains 11of the large
irregular pebbles.
COMPLETED PEBBLES
LCSII-LUMINAR SERIES OCT 2015
Advertisement
