Advertisement
WARNING: DO NOT USE LOGS OTHER THAN THOSE SUPPLIED BY THE MANUFACTURER
WHEN INSTALLING LOGS, ENSURE THAT BURNER HOLES ARE NOT BLOCKED.
Obsructing any of the burner holes may result in poor performance and can cause sooting to occur.
CAUTION: LOGS ARE FRAGILE. PLEASE TAKE CARE WHEN INSTALLING
FITTING INSTRUCTIONS FOR LOGS
NEVER FIT LOGS OR PEBBLES OTHER THAN THOSE SUPPLIED WITH THE APPLIANCE OR A HAZARDOUS SITUATION
MAY RESULT. BROKEN OR DAMAGED LOGS OR PEBBLES MUST BE REPLACED WITH THE CORRECT PART.
CONTACT YOUR NEAREST ILLUSION DEALER FOR MORE INFORMATION.
Fit the logs as shown in the photos below. Always start at the rear, then the middle, then the front. The logs
have holes to correspond with the pins near the burners.
Luminar 1000
1
Empty firebox with door removed
ready to fit the logs.
4
Next fit either the lhs (number 3) or
rhs (number 4) log to the front.
Luminar 2000
1
Empty firebox with door removed
ready to fit the logs.
4
Fit the number 3 log next on the
rhs of the middle row.
Australian Made Gas Log Fires
OR A HAZARDOUS SITUATION MAY RESULT.
2
Fit the large rear number 1 log first.
5
Fit the remaining log over the pins
and the logset is complete!
2
Fit the rear number 1 log first.
5
Now fit the number 4 log on the lhs
of the front row
3
6
11
Fit the long number 2 log next on
the middle row
3
Fit the number 2 log next on the
left hand side middle row
Finally, fit the number 5 log on the
rhs of the front row to complete
the logset.
LCSII-LUMINAR SERIES OCT 2015
Advertisement
