Download Print this page

Illusion Aussie Made LCSII-LUMINAR Series Manual page 10

Gas log fires

Advertisement

1.
These appliances must be installed in accordance with the regulations, municipal building codes and
AS 5601 'GAS INSTALLATIONS'
2.
Only an Authorised person should install the appliance.
3.
This appliance should be inspected prior to installation and the dealer contacted if any problems arise.
4.
This appliance must be installed with an approved flue system, which terminates outside the building.
A flue system must never terminate within the roof cavity.
5.
The unit should be checked periodically for lint. The fan area especially is prone to lint build up during
normal
operation. Keep the area around the appliance clean and free from lint.
6.
Only persons familiar with the operation of the unit should use the heater.
7.
Do not modify or adjust the heater. Always contact your ILLusion dealer if any problems arise.
8.
Annual service by an Authorised service person will ensure trouble free operation for many years.
9.
This Gas heater is not designed to burn solid fuels. NEVER use paper, wood or any other fuel in this
appliance.
10.
Keep the immediate area around the heater free from any combustible materials: i.e.: aerosols, or other
flammables.
11.
If you smell gas whilst the unit is operating, immediately shut down the unit and turn the gas off at the
supply shut off valve, or the main meter. Contact Illusion or your local gasfitter.
DO NOT ATTEMPT ANY REPAIRS ON THE HEATER YOURSELF. ONLY AN AUTHORISED GASFITTER MAY REPAIR OR
ADJUST THE HEATER ACCORDING TO THE MANUFACTURERS INSTRUCTIONS.
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE.
DO NOT USE OR STORE FLAMMABLE MATERIALS NEAR THIS
APPLIANCE.
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE
WHILE IT IS IN OPERATION.
CERTIFIED UNDER AS 4558 - NOT CERTIFIED AS A SPACE
HEATER.
SOME SURFACES OF YOUR ILLUSION GAS APPLIANCE HAVE BEEN FINISHED WITH HEAT RESISTANT
PAINT. OTHER SURFACES ARE POWDER COATED. PLEASE NOTE THAT THE INITIAL FIRING OF THE
UNIT MAY PRODUCE SOME SMOKE AND ODOUR AS THE PAINT ON THE FIREBOX CURES. TO ENABLE
CURING, THE UNIT MUST BE RUN ON LOW WITH THE FAN ON LOW FOR APPROX. 3 - 4 HOURS. IT IS
ADVISABLE TO KEEP WINDOWS AND DOORS OPEN DURING THIS PERIOD IF POSSIBLE.
Australian Made Gas Log Fires
SAFETY INFORMATION
PAINT CURING
10
LCSII-LUMINAR SERIES OCT 2015

Advertisement

loading