Hopper Removal; Shutdown - Graco ToughTek S340e Operation, Repair, And Parts

Hopper Removal

Hopper Removal
To help prevent injury from suction, never place
hands near the pump fluid inlet when pump is
operating or when hopper is removed.
The hopper assembly allows easy detachment of the
hopper from the pump. To remove the hopper from the
pump, perform the following steps:
1. Relive pressure, see Pressure Relief Procedure,
pg. 21.
2. Unplug the power cord.
3. Rotate knob (K) counterclockwise to loosen the
clamp between the hopper elbow and the lower.
4. Remove the locking pin and pull down the hopper
latch (U) on the hopper plate.
NOTE: If needed, push down on the hopper elbow to
completely disengage from the pump lower.
5. Remove the two hopper pins (P) from the front legs
of the cart.
6. Lift up on the handle and pull the hopper (J) away
from the sprayer.
22
NOTE: If the hopper elbow needs to be thoroughly
cleaned, rotate knob (K) to loosen the clamp between
the elbow and the hopper. Remove and clean the
elbow.
NOTE: To re-install the hopper, follow the steps above
in reverse order.

Shutdown

To prevent rust, never leave water or water-based
fluid in pump overnight.
To shutdown, flush the system, see Flush, pg. 14.
Lifting Instructions
When lifting the unit, only lift at the points indicated by
the arrows below.
NOTICE
3A3437G