Using A Cg10 Lcd Touch Panel With The Axb-Tpi/3 - AMX AXB-TPI/3 Instruction Manual

TPI Configuration and Usage
Refer to the @MOU command on page 54 for more detailed information about the variables
and the 8 - 15 BIT information.
14. Create as many video windows, on the primary TPI/3 (FIG. 8), corresponding to the number of
total TPI/3s and slot cards stacked together.
FIG. 8 Sample primary TPI/3 touch screen
In the above example, there are three TPI/3s (each with three occupied slot cards outputting a
VGA/RGB signal) stacked together. The primary TPI/3 would need to display three video
windows, each with three video windows to correspond to the output from the slot cards on
each TPI/3.
15. Exit Terminal Emulator mode.

Using a CG10 LCD Touch Panel with the AXB-TPI/3

1. Connect the DB-9 from the Mouse port, the HD-15 from the Monitor Out port, and the AXlink
cable on the rear of the AXB-TPI/3 to their respective connectors on the rear of a 10.4" Color
Graphic Active-Matrix LCD touch panel.
2. Supply power to the AXB-TPI/3 using an auxiliary 12 VDC power supply.
3. Supply power to the touch panel through the use of an AXlink cable or an auxiliary power
supply.
4. Power both units On.
5. Go to the Protected Setup page on the touch panel and press
calibration process for the touch panel. Refer to the Activating Edit Mode section on page 28
for information on accessing the Protected Setup page.
6. Be sure the device base numbers for both units are different.
7. Press
8. Press
allows you to view the graphics as a background color on the selected page and not as a
24
TPI/3 #3
Card #3
TPI/3 #3
Card #1
TPI/3 #4 TPI/3 #4
Card #2
Card #3
TPI/3 #4
Card #1
on the Edit bar of the touch panel to open the PAGE menu.
PAGE
from the color palette and select
PAGE COLOR
TPI/3 #3
Card #2
TPI/3 #2 TPI/3 #2
Card #2
Card #3
TPI/3 #2
Card #1
CALIBRATE
VGA PAGE
to begin the
from the options. This option
AXB-TPI/3 Touch Panel Interface 3