Table of Contents
Advertisement
Configuration
Logging Into the Configuration Manager (With Security Enabled)
Login is only required if the Web and/or Admin security options have been enabled on the unit.
1.
Click the Login link in the upper-right corner of the initial page (FIG. 1). This invokes the Login popup
page (FIG. 5).
FIG. 5
NXB-KNX Configuration Manager - Login popup page
Enter the default login information:
2.
Click the Login button.
Once you have successfully logged into the Configuration Manager, the IP Settings page is displayed, and can
be edited as needed.
IP Settings
Select IP Settings from the Admin drop-down menu to open the IP Settings page (FIG. 6). Use the options on
the page to specify network/IP settings for this NXB-KNX unit.
FIG. 6
IP Settings page
8
Click Accept to save your changes. Note that changes on this page take effect immediately.
Click Cancel to cancel any changes.
Username = administrator
Password = password
DHCP:
Click to toggle DHCP on this unit (default = enabled).
Note that DHCP must be enabled in order for the zero-configuration client (i.e.
Bonjour for Windows) to detect the NXB-KNX on the network.
See the Bonjour (Zero-Configuration) Client section on page 5 for details.
Hostname:
Enter a Hostname for this unit (enabled only if DHCP is disabled).
IP Address:
Enter an IP Address for this unit (enabled only if DHCP is disabled).
Subnet Mask:
Enter a Subnet Mask for this unit (enabled only if DHCP is disabled).
Gateway:
Enter a Gateway for this unit (enabled only if DHCP is disabled).
NXB-KNX NetLinx KNX Interface
Advertisement
Table of Contents
