Chrysler Pacifica 2021 Owner's Manual page 309

To move the vehicle in cases where the
transmission will not shift out of PARK (P) (such as
a depleted battery), a Manual Park Release is
available.
Manual Park Release Access Cover
Follow These Steps To Activate The Manual Park
Release:
1. Apply firm pressure to the brake pedal while
seated in the driver's seat.
2. Apply the parking brake, if possible.
3. Using a small screwdriver or similar tool,
remove the Manual Park Release access
cover, which is to the lower left of the steering
column.
4. The Manual Park Release access cover is
connected to a red tether strap. Pull the tether
strap out as far as it will go, then release it. The
transmission should now be in NEUTRAL (N),
allowing the vehicle to be moved.
Tether Strap
IN CASE OF EMERGENCY
NOTE:
When the lever is locked in the released position,
the tether will remain outside of the trim panel and
the access cover cannot be reinstalled.
5. Release the parking brake only when the
vehicle is securely connected to a tow vehicle.
To Reset The Manual Park Release:
1. Apply firm pressure to the brake pedal while
seated in the driver's seat.
2. Pull the tether strap out again, then release it.
3. Allow the tether to retract with the lever back
to its original position.
4. Verify that the transmission is in PARK (P).
5. Confirm that the tether has retracted fully
and re-install the access cover. If the
access cover cannot be re-installed, repeat
steps 1 through 4.
307
7