Maintenance - HMS LOOP06 Manual Instruction

EN
SAFETY INSTRUCTION
In order to avoid any injury,please read instruction manual carefully before using.
(1) Do not insert any other things into any parts.
(2) Make sure you are in good condition. People who feel uncomfortable(dizzy,headache,ligament injury, joint replace etc),has
mental defects or lack of sport experience are forbidden to use.
(3) Start walking/running 40 mins after meal.
(4) User age is 18+. Children and elderly people are not suitable for use.
(5) This product is for home use only.Not suitable for professional training and test. Not suitable for medical purpose.
(6) Check product carefully before using,and put product on flat and open floor. Make sure there are no sharp things around.
(7) Do not close to water,heat,and highlight.
(8) Wear casual and comfortable clothes when running/walking. Do not wear any decoration when running/walking.
(9) Do not insert hand,foot or other parts into LOOP walk or the intervals between running belt and foot rails.
(10) For 1 person use only. More than 1 user is forbidden in one tine use.
(11) Use original parts only.
(12) Max loading is 100 kgs
(13) Please stop 30 mins after 1houe's running.Avoid any damage to the mother due to the overheat.
(14) Disconnect the plug when LOOP WALK won't be used for a long time .Plug all the may cause some potential dangers for LOOP
WALK for human body.
(15) If wall suction storage is used,make sure the magnets are attracted to the steels.Forbidden to move randomly.
(16) Use LOOP WALK properly leave away from sport injury. Do warm up exercises before walking/running. Do not excessive
exercise.(17) If there are any emergency situation that speed is out of control, jump off from the LOOP walk from left or right
sides and unplug it.
(18) Please use original wires once the previous wires are broken. Contact retailers for buying original wires and other parts.
(19) The cable is not allowed to be extended. Do not replace the plug by yourself. Do not load anything on plug and wire. Do not
use power strip. Connect to wall socket only.
IMPORTANT NOTICE
(1) Use qualified wall socket, and make sure plug is tight. If Plug and socket is incompatibility, please change to compatibility socket
to avoid dangerous will be caused.
(2) Do not contact cable to any other parts such as cylinder, running belt etc. Damaged plug is forbidden for use.
(3) Do not use in such conditions: outdoor, high humidity, high light, direct sun exposure.
(4) Do not stamping on display.
(5) Do not overload on LOOP WALK.
(6) Do not disassemble any parts forcibly.
(7) Do not cut power off when in using.
(8) Please cut power off and make sure there is no water percolation before daily cleaning and maintain for JMG MINI WALK.

MAINTENANCE

Maintenance of running belt
Running board and running belt for LOOP WALK is overall upgraded. Density and lubrication is improved 10-15times.
Friction coefficient is much less than traditional treadmill. Using lubricating oil makes LOOP WALK in best condition. Please check
every 30 hours or 30 days use by touching the inside of running belt. Touch the inside part of running belt as far as possible from
the backside of LOOP WALK, if it is lubricated, then no need to add lubricating oil. If it is very dry, please add lubricating oil as in
below pics.