Prepare For Setup - NEC N8103-91 User Manual

5-1. Prepare for setup

Notice
9.
Exit from all applications and shutdown OS.
10.
Press the POWER switch on the server to turn off the power of the server.
11.
Pull out all the power cords connected to the power unit of the server from the
receptacles.
12.
Remove the side cover on the server following the procedure described in the
User's Guide of the server.
Check
Note the following before the setup.
Only a single disk array controller can be installed in a server.
Some limitation may be imposed to the installation on the PCI slot (PCI
Express) depending on the type of the server. Before the installation,
check the limitation following the User's Guide of the server.
HDDs to be connected to the disk array controller should have the same
specification. Contact your service representative for HDDs which can be
connected to the disk array controller.
Coexistence with other PCI boards (including disk array controller,
mirroring board, and SCSI controller) may be limited. Before using the
disk array controller together with other PCI boards, ask your service
representative whether the disk array controller can coexist with the
other PCI boards.
For the installation or removal of the side cover and other components on
the server, refer to the User's Guide of the server.
81