Table of Contents
Advertisement
For tyres with a specified direction of rotation,
an arrow on the side wall of the tyre indicates
the correct direction of rotation. Observe the
direction of rotation when fitting.
Place the wheel to be fitted on the wheel hub
#
and push it on.
& WARNING Risk of injury from tightening
wheel bolts and nuts
If you tighten the wheel bolts or wheel nuts
when the vehicle is raised, the jack could tip.
Only tighten wheel bolts or wheel nuts
#
when the vehicle is on the ground.
For safety reasons, only use wheel bolts
#
which have been approved by Mercedes-
Benz and for the wheel in question.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated until they are
finger-tight.
Lower the vehicle (
page 423).
/
#
Lowering the vehicle after a wheel change
Requirements:
The new wheel has been fitted
R
(
page 422).
/
Place the ratchet onto the hexagon nut of the
#
jack so that the letters "AB" are visible.
To lower the vehicle: turn the ratchet of the
#
jack anti-clockwise.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated
Specified tightening torque: 150 Nm.
& WARNING Risk of injury through incor‐
rect tightening torque
The wheels could come loose if the wheel
bolts or wheel nuts are not tightened to the
prescribed tightening torque.
Make sure the wheel bolts or wheel
#
nuts are tightened to the prescribed
tightening torque.
If you are not sure, do not move the
#
vehicle. Consult a qualified specialist
workshop and have the tightening tor‐
que checked immediately.
Check the tyre pressure of the newly moun‐
#
ted wheel and adjust accordingly.
Vehicles with a tyre pressure monitoring
#
system: restart the tyre pressure monitoring
system (
Make sure to observe the following further rela‐
ted subject:
(1
to 5).
Notes on tyre pressure (
R
Wheels and tyres 423
page 412).
/
page 409)
/
Advertisement
Table of Contents
