Table of Contents
Advertisement
420 Wheels and tyres
Raising the vehicle when changing a wheel
Requirements:
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
R
change (
page 419).
/
The hub caps have been removed
R
(
page 419).
/
Fitting the jack
Assemble pump lever 1.
#
Place pump lever
1
with the recess on low‐
#
ering screw
2
on the jack.
Turn pump lever
1
clockwise as far as it will
#
go.
Lowering screw
2
is closed.
3
Adapter
To raise the vehicle at the front: adapter
must be secured on the jack.
To raise the vehicle at the rear: remove
adapter
3
from the jack.
Important notes on using the jack:
Only use the vehicle-specific jack that has
R
been tested and approved by Mercedes-Benz
to raise the vehicle.
The jack is only designed for raising and
R
holding the vehicle for a short time while a
wheel is being changed and not for mainte‐
nance work under the vehicle.
The jack must be placed on a firm, flat and
R
non-slip surface. If necessary, use a large,
flat, load-bearing, non-slip underlay.
The jack may only be positioned at the jack
R
support point.
Rules of conduct when the vehicle is raised:
Never place your hands or feet under the
R
vehicle.
Never lie under the vehicle.
R
3
Do not start the engine and do not release
R
the electric parking brake.
Do not open or close any doors or the rear-
R
end door.
Advertisement
Table of Contents
